Delta Power Solutions Amplon RT 6K Rack/Tower Online UPS - 6000 W / 6000 VA - 6 C13 + 3 C19 Outlets (UPS602R2RT0B035)

Delta Amplon RT 6K · Part number UPS602R2RT0B035

Six clean kilowatts,
without a single break.

An online double-conversion UPS designed for a server room or a network rack: it constantly regenerates a stable sine-wave voltage, fits a 19-inch rack or stands as a tower, and can be serviced without shutting down what it protects.

• 6 000 Wusable, power factor 1
• 95.5 %efficiency in double conversion
• 4UUPS and batteries, rack or tower

The 6 kVA on the label, in watts

Its output power factor is 1: the 6,000 VA deliver 6,000 W actually available. At a factor of 0.9, the same label would only provide 5,400. Output voltage is held within ± 1 %, with distortion below 2 % on a linear load, and the unit withstands an overload of 106 to 125 % for two minutes.

On the input side, it accepts 175 to 280 V at full load and goes down to 100 V when the load does not exceed half: an unstable mains supply does not send it to battery at every dip. With an input power factor of 0.99 and current distortion below 3 %, it is also gentle on an upstream generator.

Nine outlets, and one that knows when to stop

Rear panel of the UPS602R2RT0B035, from the Delta manual drawing

Six C13 and two C19 outlets power servers, storage arrays and switches, each group protected by its own circuit breaker. A third C19 is programmable: on battery, it cuts the secondary equipment plugged into it after an adjustable delay of 1 to 240 minutes, leaving all the remaining energy to critical machines. An output terminal block completes the set for hardwired equipment.

Time to shut down, or to go further

With its 16 internal 12 V / 7 Ah batteries, it runs 3 minutes at full load, 5.5 minutes at 75 % and 9.6 minutes at half load: enough to wait for a generator to start or to close the servers properly. For longer runtime, it takes the optional Delta BBU161B107035 external battery module. It also starts on battery without mains power, and recharges to 90 % in under three hours.

Maintenance without downtime

A manual bypass switch at the rear puts the equipment directly on mains power during servicing: the service carries on while the UPS is being worked on. In ECO mode, when the mains stays within ± 10 % of its voltage and ± 3 Hz of its frequency, it feeds the loads directly and reaches up to 99 % efficiency.

Supplied with its rail kit and brackets for the rack, it also stands upright on the four feet and their extenders included in the box.

Monitored like the rest of the room

Delta's UPSentry 2012 software connects over USB or RS-232 to monitor the UPS and shut down the servers. An RS-485 port, a REPO/ROO emergency power-off contact and four dry contacts tie it into the installation: the input contact can, for example, signal that the site is running on a generator. The MINI slot takes an optional SNMP network card, relay card or Modbus card.

Composition

UPS, batteries, PDB box

C13 outlet

10 A max per outlet

C19 outlet

16 A max per outlet

Advised protection

50 A D-curve breaker

Altitude

3,000 m, derated above 1,000

Temperature

0 to 40 °C in operation

This UPS has no input plug: it connects through a terminal block, on a dedicated single-phase line, and this wiring should be entrusted to an electrician. Also check the usable depth of your rack: the unit is 665 mm deep and weighs 54 kg.

Other double-conversion models in the online UPS section, the full Delta Power Solutions range, and all our UPS.

Values taken from the Delta RT Gen2 5-10 kVA user manual, its datasheet and its specifications page, for part number UPS602R2RT0B035.