Additional battery modules extend runtime well beyond the 10 minutes held at half load (2500 W). 5000 W genuinely usable, with two batteries already fitted as standard.
Usable power 5000 W
Battery life 10 minutes at half load (2500 W)
Battery life 3 minutes 30 at full load
Runtime extendable with SRTG192XLBP4 battery modules
2 pre-installed batteries
2 C13 outlets, the format of computer and server power cords
1 reinforced 16 A C19 outlet for power-hungry equipment
3-wire terminal block output also available: fixed wiring by an electrician
Sine wave output
Automatic and manual internal bypass
LCD status and control display
Emergency power off button (EPO)
Rack mounting with a kit
Full battery recharge in 4 hours
Noise level 55 dB: to be installed in a technical room
High-power online UPS for server rooms: online double-conversion, 5000 VA / 5000 W. Technology & protection: power is continuously rebuilt — your equipment receives perfect power without ever touching the mains, with zero transfer time. Maximum protection against power cuts, surges, voltage fluctuations and electrical noise. Power: 5000 VA for 5000 W of usable power (power factor of 1) — enough to run several servers and network equipment, for example. Runtime: approx. 10 minutes at half load (2500 W). Outlets: 2 C13 outlets + 1 heavy-duty C19 outlet for power-hungry equipment. Like every online model, it uses active cooling: install it in a technical room. LCD display: shows load, battery level and remaining runtime at a glance — monitor the UPS without any software. Designed, for example, for server racks and critical infrastructure. Remember to check how much power your equipment draws and to choose the capacity according to the runtime you need.
Be the first to review this product and help other customers.
Write a review
Frequently asked questions about this product
How long does the SRTG5KXLI last on battery?
10 minutes at 50% load, i.e. 2500 W, 6 minutes at 70% and 3 minutes 30 seconds at full load. Three reference points for three different situations: the one that matches your actual load is the one to go by.
Does this 5 kVA really deliver 5000 W?
Yes, its power factor is 1: the 5000 VA are fully available in watts. On a UPS with a 0.8 power factor, only 4000 would remain for the same rated power — it is the figure in watts that determines what you can connect.
What outputs does the SRTG5KXLI offer?
Three types at once: two C13 outlets, one heavy-duty C19 outlet, and a 3-wire terminal block output for fixed wiring installed by an electrician. The input, for its part, is via a 3-wire terminal block only.
Can the runtime of the SRTG5KXLI be extended?
Yes, with additional battery packs, part number SRTG192XLBP4, on top of the two batteries already installed. A full recharge takes 4 hours.
How much space does the SRTG5KXLI take up in a rack?
17.78 cm high, 44 cm wide and 62 cm deep, for 51.9 kg, with a rack-mount kit. At this weight, mounting it in the rack takes several people and the unit goes at the bottom of the cabinet.
What input voltage does the UPS accept?
160 to 285 V, with an adjustable setting of up to 100-280 V. Frequency is accepted from 40 to 70 Hz: this wide range lets it cope with a severely degraded grid without drawing on the batteries.
Can work be done on the UPS without shutting down the servers?
Yes, thanks to the automatic and manual internal bypass: the automatic bypass takes over on a fault, while the manual one allows a deliberate transfer to direct mains power. Conversely, an emergency power-off button lets you cut everything in one move.
How do you know the UPS is overloaded or on battery?
Through a multifunction LCD console and an online/on-battery status indicator, backed by three distinct audible alarms: switch to battery mode, low battery threshold and a continuous tone in the event of overload.
What is in the box, and how do you manage the UPS?
A USB cable, an RS-232 cable and the user manual: both communication links are therefore supplied, and automatic server shutdown is possible from commissioning.
Is the APC Smart-UPS RT SRTG5KXLI new and under warranty?
Yes, new equipment, with the invoice serving as the warranty document, for a period of 3 years. It delivers a sine wave and is rated at 55 dBA: it is a fan-cooled unit, to be installed in a technical room. The datasheet details the rest.
Three-phase online UPS rated 20 kVA for 20 kW, configurable as 3:3, 3:1 or 1:1. Supplied without batteries: 32 to 40 12 V blocks inside, or external cabinets. Up to 98.5% efficiency in ECO mode, maintenance bypass and touch screen.
•20 kVA / 20 kW: output power factor 1.0
•Three-phase or single-phase: 3:3, 3:1 or 1:1 configurations
16 kW genuinely available and around 14 minutes of runtime at half load, extendable with up to four battery cabinets. Terminal block input and output, for hard-wired infrastructure.
•16 kW usable output
•Around 14 minutes of runtime at half load
•Runtime extendable with one to four external battery cabinets
Ten battery-backed outlets, four of them heavy-duty 16 A, for 4 500 W usable and around 11 minutes of runtime at half load (2 250 W). The Web/SNMP management card is included.
•4 500 W usable output (power factor of 0.9)
•Around 11 minutes of runtime at 50% load (2 250 W), 7 minutes at 70% (3 150 W)
•6 C13 outlets, the format used by computer and server power cords, all battery-backed
Power factor of 1: all 8 000 W stated are available. Ten battery-backed outlets, four of them heavy-duty 16 A, and the Web/SNMP network management card is included.
•8 000 W usable output (power factor of 1)
•6 C13 outlets, the format used by computer and server power cords, all battery-backed
•4 C19 outlets, heavy-duty 16 A, also battery-backed
A free-standing tower on castors, with an LCD screen showing the load, the battery status and the voltages. Around 16 minutes of runtime at half load, extendable with up to four battery cabinets.
•Around 16 minutes of runtime at half load
•Runtime extendable with one to four external battery cabinets
Three reinforced 16 A outlets for power-hungry hardware, eight server outlets, and batteries that are changed without cutting the power. Under 40 dB at one metre, in a rack as in a tower.
•8 C13 outlets: the format of computer and server power cords
A maintenance bypass supplied as standard allows the UPS to be replaced without shutting down the equipment it powers. Around 15 minutes of runtime at half load (4 000 W), extendable with four battery cabinets.
•Around 15 minutes of runtime at half load (4 000 W)
•Runtime extendable with one to four external battery cabinets
Built for the server room: 8 C13 outlets, 2 C19 and a hardwired output, 98% efficiency in eco mode and runtime expandable with external battery modules. Hot-swappable batteries, managed over USB, RS232 or an optional network card.
A 15 kVA / 15 kW double-conversion online three-phase UPS with internal batteries, for a technical room or a small server room. It lasts 33 minutes at half load, accepts an additional battery module and can be paralleled up to four units.
All the power available in watts: 10,000 W usable, as many as the VA. Around 7 minutes of runtime at half load (5000 W) to shut down a full rack cleanly, in only 4U.
•Usable power 10,000 W
•Runtime 7 minutes at half load (5000 W)
49 999 DHincl. VAT49 999,00 DHincl. VAT
Delivery everywhereDelivered all over Morocco
In stock
47 999 DHincl. VAT47 999,00 DHincl. VAT
Delivery everywhereDelivered all over Morocco
In stock
61 799 DHincl. VAT61 799,00 DHincl. VAT
Delivery everywhereDelivered all over Morocco
•Internal bypass and maintenance bypass as standard
In stock
41 999 DHincl. VAT41 999,00 DHincl. VAT
Delivery everywhereDelivered all over Morocco
•3 C19 outlets: reinforced 16 A outlets for power-hungry equipment
•Terminal block input: fixed wiring, to be installed by an electrician
In stock
39 099 DHincl. VAT39 099,00 DHincl. VAT
Delivery everywhereDelivered all over Morocco
•Internal bypass and maintenance bypass as standard
Four U in a rack and a battery recharged in 3 hours: it is ready to go again quickly after a cut. Around 11 minutes of runtime at half load (3000 W) and 7 minutes at 70%.
A 6000 VA / 6000 W double-conversion online UPS delivered complete: 2U power module, 3U SRV240RLBP-9A external battery pack and rail kit. Terminal-block connection, pure sine wave output, 94 % efficiency and runtime expandable up to four packs.
Nineteen minutes of runtime at half load, extended to fifty with an additional battery cabinet. The 16 12 V batteries are chosen and ordered separately.
Floor-standing, 68.5 cm high and 54 kg: the tower version, for when there is no rack. Around 11 minutes of runtime at half load (3000 W) and 94% efficiency at full load.
All the power available in watts: 10,000 W usable, as many as the VA. Around 7 minutes of runtime at half load (5000 W) to shut down a full rack cleanly, in only 4U.
Built for the server room: 8 C13 outlets, 2 C19 and a hardwired output, 98% efficiency in eco mode and runtime expandable with external battery modules. Hot-swappable batteries, managed over USB, RS232 or an optional network card.
Online double-conversion UPS rated 6000 VA for 6000 W, with no internal battery: it runs on one to four external cabinets. With one 2U cabinet of 16 HR09122F batteries, it holds 17 min at half load and 5 min at full load.
Network management card already fitted, with environmental monitoring: it is administered and raises alerts remotely. 9 minutes of runtime at 50% load (10 kW), extendable with battery packs.
•Runtime: 9 min at 50% load (10 kW), 5 min at 70% (14 kW)
Doubling the runtime comes down to one extra battery cabinet: 9 minutes at half load become 23 minutes. The 16 12 V batteries are chosen and ordered separately.
Twenty minutes of runtime at half load (2 400 W), extended to several hours with up to four external battery cabinets. The standard maintenance bypass allows the unit to be swapped without shutting down the equipment.
•Around 20 minutes of runtime at half load (2 400 W)
