Eaton 9PX 3000 VA Online UPS - RT 3U (9PX3000IRTBPF)
Devices plug straight into four FR outlets, with no adapter or special cord. 3000 W genuinely available for 3000 VA, a graphic LCD display and a slot for a network management card.
4 FR outlets: devices plug straight in, with no adapter
3000 W genuinely available, power factor of 1
USB port and RS-232 serial port for automatic server shutdown
Slot for an SNMP, Modbus or dry contact network card
Pure sine wave output
Multilingual graphic LCD display
Shallow 3U format, tower-convertible, brackets included
Accepted input voltage from 176 to 276 V
Noise level below 40 dBA
Weight 27.4 kg
Ref.: 9PX3000IRTBPF
Out of stock
1/2
27 799,00 DHincl. VAT
Out of stock
Product overview
A high-end online UPS, convertible between rack and tower: online double conversion, 3000 VA / 3000 W, 3U format. Technology & protection: power is fully and continuously regenerated — your equipment is never exposed to the mains, with zero transfer time. Complete protection against outages, surges, voltage fluctuations and electrical noise. Power: 3000 VA for 3000 W of real power — its power factor of 1 makes all of the rated power available in watts. Outlets: 4 French-standard outlets — plug your devices in directly, no adapter needed. Management: USB port and RS-232 serial port for automatic shutdown; slot for an SNMP network card. Pure sine wave output; low-noise operation (under 40 dB). Ideal, for example, for a server, a demanding workstation or network equipment. Remember to check how much power your equipment draws and to choose the rating according to the runtime you need.
176 - 276 V without derating (up to 100 - 276 V with derating)
Battery replacement
User-replaceable, hot-swappable (no power interruption)
Battery management
ABM® or temperature-compensated charging method (user-selectable), automatic battery test, deep discharge protection, automatic recognition of external batteries
Interface port
1 USB port, 1 RS232 serial port, 1 remote ON/OFF mini terminal block, 1 remote power-off mini terminal block, 1 output relay mini terminal block
User interface
Multilingual graphic LCD display
Audible alarm
Yes
Power management software
Eaton Intelligent Power
Weight (kg)
27.4 kg
Dimensions (W x D x H) (mm)
440 x 485 x 130 mm
Technology
On-line
Power (VA)
3,000 VA
Voltage stabiliser
Yes
Box contents
9PX UPS · 2 IEC output power cords · USB cable · Serial cable · 2 brackets for tower mounting · 2 brackets for 19-inch mounting · 2 universal rails · Cable locking systems · Safety guide · Quick start
Technical specifications (continued)
Communication card slot
1 slot for Network-MS, ModBus-MS or Relay-MS card (optional)
Rack height
3U
Transfer/switching time
0 ms (continuous double conversion)
Bypass
Internal bypass + HotSwap MBP maintenance bypass as standard
Audible noise
< 40 dBA
Power factor (ratio)
1
Input power factor
Input power factor correction (PFC), ratio not published by the manufacturer
Output frequency
50 - 60 Hz
Phase (output/input)
Single-phase / Single-phase
Eco mode efficiency
98% in high-efficiency mode
Double-conversion efficiency
Up to 94% in online mode
Output type
FR outlets
Power (W)
3,000 W
Runtime
60 min at 300 W; 36 min at 500 W; 22 min at 800 W; 13 min at 1,200 W; 7 min at 1,800 W; 4 min at 2,500 W
External battery packs
Up to 4 hot-swappable external battery modules (EBM 9PXEBM72RT3U)
Form factor
Convertible rack/tower
Battery-backed outlets
3 to 4 outlets
Control & communication
USB, RS232 serial port, Card slot
Warranty
1 year
Specific references
EAN
743172081506
Customer reviews
No reviews yet
Be the first to review this product and help other customers.
Write a review
Frequently asked questions about this product
Does this 9PX 3000 have French outlets?
Yes, and that is what sets it apart: four French outlets on the output side, into which you plug your devices directly — with no adapter or IEC cord, unlike almost every other UPS in this range.
Does this 3000 VA unit really deliver 3000 W?
Yes: the power factor is 1, so the full 3000 VA is available in watts. On a conventional UPS with French outlets, whose power factor is around 0.6, only 1800 would be left.
How does the 9PX3000IRTBPF connect to the mains?
Via a heavy-duty C20 inlet — the 16 A format, not the C14 of a desktop UPS. The accepted range runs from 176 to 276 V, with automatic 50/60 Hz selection.
What is the benefit of this model's shallow 3U format?
It is only 485 mm deep, for 440 wide and 130 high, i.e. 3U. It therefore fits into shallow cabinets where a longer 2U unit will not, and converts to a tower, brackets supplied.
Is the output a pure sine wave?
Yes, the output is a pure sine wave, continuously regenerated by double conversion. The output frequency is held at 50 or 60 Hz.
How do you monitor the 9PX3000IRTBPF?
Through a USB port, an RS-232 serial port and three mini terminal blocks — remote on/off, remote power off, relay output. A slot accepts a Network-MS, ModBus-MS or Relay-MS card.
Is this 9PX 3000 with French outlets noisy?
It stays below 40 dBA, which is low for a 3000 VA double-conversion unit. Allow for 27.4 kg: it has to sit on the floor or at the bottom of the rack.
Is the Eaton 9PX 3000 RT3U (9PX3000IRTBPF) new and under warranty?
Yes, new equipment, with the invoice serving as the warranty document. It displays its status on a multilingual graphical LCD screen, and its battery can be extended with an external EBM 3U module.
Four U in a rack and a battery recharged in 3 hours: it is ready to go again quickly after a cut. Around 11 minutes of runtime at half load (3000 W) and 7 minutes at 70%.
Built-in network card: monitoring and control happen remotely, from the company network. 1980 W genuinely available and ten output sockets, two of them reinforced 16 A, in a chassis meant for the rack.
A maintenance bypass supplied as standard allows the UPS to be replaced without shutting down the equipment it powers. Around 15 minutes of runtime at half load (4 000 W), extendable with four battery cabinets.
•Around 15 minutes of runtime at half load (4 000 W)
•Runtime extendable with one to four external battery cabinets
For a whole infrastructure: 9 minutes of runtime at half load (5000 W) and 5 minutes at 70%, the time it takes to switch over to a generator. 94% efficiency at full load and internal bypass.
All the power available in watts: 10,000 W usable, as many as the VA. Around 7 minutes of runtime at half load (5000 W) to shut down a full rack cleanly, in only 4U.
Twenty minutes of runtime at half load (2 400 W), extended to several hours with up to four external battery cabinets. The standard maintenance bypass allows the unit to be swapped without shutting down the equipment.
•Around 20 minutes of runtime at half load (2 400 W)
•Runtime extendable with one to four external battery cabinets
Every outlet is battery-backed, with around 11 minutes of runtime at half load (990 W). Automatic and manual internal bypass, LCD screen and a detachable 2.44 m cord supplied.
Floor-standing, 68.5 cm high and 54 kg: the tower version, for when there is no rack. Around 11 minutes of runtime at half load (3000 W) and 94% efficiency at full load.
Three reinforced 16 A outlets for power-hungry hardware, eight server outlets, and batteries that are changed without cutting the power. Under 40 dB at one metre, in a rack as in a tower.
•8 C13 outlets: the format of computer and server power cords
Doubling the runtime comes down to one extra battery cabinet: 9 minutes at half load become 23 minutes. The 16 12 V batteries are chosen and ordered separately.
•
•
Built-in network card to monitor and control the UPS remotely
•1980 W genuinely available
•8 C13 outlets, the format of computer and server power cords
In stock
27 099 DHincl. VAT27 099,00 DHincl. VAT
Delivery everywhereDelivered all over Morocco
•Internal bypass and maintenance bypass as standard
In stock
29 999 DHincl. VAT29 999,00 DHincl. VAT
Delivery everywhereDelivered all over Morocco
Runtime 5 minutes at 70% load (7000 W)
•3-wire terminal block connection: fixed wiring, to be installed by an electrician
Up to four external battery modules extend the 10.5 minutes of runtime at half load. The 2U rack mounting kit, the output cords and the USB cable are included.
•Runtime: 10.5 min at half load, 3.5 min at full load
•Runtime extendable by up to 4 external battery modules
•C13 outlets: the format of computer and server power cords
Twenty minutes of runtime at half load (2 400 W), extended to several hours with up to four external battery cabinets. The standard maintenance bypass allows the unit to be swapped without shutting down the equipment.
•Around 20 minutes of runtime at half load (2 400 W)
2400 W genuinely available and 13.5 minutes of battery life at half load (1200 W): time enough to save and shut down cleanly. Under 37 dB, it can stay beside the workstation it protects.
Quiet at under 37 dB, it holds 11.5 minutes at half load (400 W): enough to save and shut down a NAS or a small server without losing anything. Its batteries are replaced without cutting the power.
•11.5 minutes of runtime at half load (400 W)
•5 minutes of runtime at full load
•4 C13 outlets, the format used by computer and server cords
Every outlet is battery-backed, with around 11 minutes of runtime at half load (990 W). Automatic and manual internal bypass, LCD screen and a detachable 2.44 m cord supplied.
Compatible with Synology NAS units over USB: the NAS shuts itself down cleanly when the battery runs low. Around 6 minutes of runtime at half load (400 W), for under 40 dB in operation.
Ten battery-backed outlets, four of them heavy-duty 16 A, for 4 500 W usable and around 11 minutes of runtime at half load (2 250 W). The Web/SNMP management card is included.
•4 500 W usable output (power factor of 0.9)
•Around 11 minutes of runtime at 50% load (2 250 W), 7 minutes at 70% (3 150 W)
Three reinforced 16 A outlets for power-hungry hardware, eight server outlets, and batteries that are changed without cutting the power. Under 40 dB at one metre, in a rack as in a tower.
•8 C13 outlets: the format of computer and server power cords
26 minutes of runtime for 400 W drawn, 12 minutes at half load (800 W): ample time to save and shut down cleanly. The LCD display shows the load and the remaining runtime without any software.
16 minutes of runtime at half load (800 W), and under 37 dB: it can sit next to a workstation without being heard. Its batteries are replaced without cutting the power.
•16 minutes of runtime at half load (800 W)
•7 minutes of runtime at full load
•6 C13 outlets, the format used by computer and server cords