Eaton 9SX 5000i 5000 VA Online UPS - RT3U (9SX5KiRT)
4,500 W usable thanks to the 0.9 power factor, and around 13 minutes of runtime at 50% load (2,250 W): time enough to shut a rack down cleanly. The software included shuts the servers down on its own when the battery runs low.
Usable power of 4,500 W (0.9 power factor)
Runtime of around 13 minutes at 50% load (2,250 W), 10 minutes at 70%
8 C13 outlets, the format of computer and server power cords
2 C19 outlets, reinforced 16 A for power-hungry equipment
Output also available on a terminal block
2 controllable outlet groups: cut the non-essential first
USB port and RS-232 serial port for automatic server shutdown
Slot for an SNMP network card, remote monitoring
Intelligent Power software included, compatible with VMware and Hyper-V
Internal bypass: power still flows even if the UPS develops a fault
Hot-swappable batteries from the front panel
Runtime extendable with external battery cabinets, detected automatically
Multilingual graphic LCD display, rotatable for rack or tower
High-end online UPS, convertible to rack or tower: online double-conversion, 5000 VA / 4500 W, 3U form factor. Technology & protection: power is fully regenerated, continuously — your servers never touch the mains, with no transfer time. Complete protection against power cuts, surges, voltage fluctuations and electrical noise. Power: 5000 VA for 4500 W of usable power (power factor of 0.9) — almost all of the rated power is available in watts. Runtime: approx. 13 minutes at half load (2250 W), 10 minutes at 70%. Ports: 8 C13 outlets + 2 heavy-duty C19 outlets + terminal block. Active cooling (≈ 45 dB), best installed in a technical room. Designed, for example, for servers, storage or critical network racks. LCD display: shows load, battery level and remaining runtime at a glance — monitor the UPS without any software. Remember to check how much power your equipment draws and to choose the capacity according to the runtime you need.
Be the first to review this product and help other customers.
Write a review
Frequently asked questions about this product
How long does the 9SX 5000i last on battery?
13 minutes at 50% load, i.e. 2250 W, and 10 minutes at 70%, i.e. 3150 W. Runtime can be extended with hot-swappable external battery modules, which the UPS detects automatically.
What exactly is in the 9SX 5000i box?
The UPS, two IEC-IEC cords, two rack-mount kits, a cable locking system and the safety instructions. Rack mounting therefore requires no additional accessories.
Does this 5 kVA unit really deliver 4500 W of usable power?
Yes, thanks to its 0.9 power factor: 5000 × 0.9 = 4500 W. The 9SX also has built-in input power factor correction, which limits the harmonic pollution sent back onto the grid.
What outputs does the 9SX 5000i offer?
Eight C13 outlets, two heavy-duty C19 outlets and a terminal block output. The input is on a terminal block: fixed wiring, to be done by an electrician before commissioning.
Can some equipment be shut down before the rest during an outage?
Yes: two controllable outlet groups let you switch off non-essential equipment first and save the battery for critical machines. That is extra runtime gained with no additional hardware.
How do you cleanly shut down virtualised servers?
The Intelligent Power software is supplied and covers VMware and Hyper-V environments. It communicates with the UPS via the USB port or the RS-232 serial port — the two cannot be used at the same time.
Can the 9SX 5000i be installed in a rack or as a tower?
Both: a convertible 3U chassis measuring 440 × 130 × 685 mm and weighing 48 kg, with a multilingual graphic LCD screen that rotates to suit the chosen position. At this weight, rack mounting is a two-person job.
Does power keep flowing if the UPS develops a fault?
Yes, an internal bypass keeps the load supplied if the UPS fails or in the event of a downstream short circuit. The unit also measures its own energy consumption, which is shown on the screen.
Is the network management card included?
No: it is only included as standard on the Netpack versions. On this model, the slot is free and accepts a Network-MS (SNMP), ModBus-MS or Relay-MS dry-contact card, to be ordered separately.
Is the Eaton 9SX 5000i (9SX5KIRT) new and under warranty?
Yes, new equipment, with the invoice serving as the warranty document, for 2 years. It delivers a sine wave, stays below 45 dB and has batteries that are hot-swappable from the front panel. The datasheet covers the rest.
All the power available in watts: 10,000 W usable, as many as the VA. Around 7 minutes of runtime at half load (5000 W) to shut down a full rack cleanly, in only 4U.
Three reinforced 16 A outlets for power-hungry hardware, eight server outlets, and batteries that are changed without cutting the power. Under 40 dB at one metre, in a rack as in a tower.
•8 C13 outlets: the format of computer and server power cords
For a whole infrastructure: 9 minutes of runtime at half load (5000 W) and 5 minutes at 70%, the time it takes to switch over to a generator. 94% efficiency at full load and internal bypass.
A maintenance bypass supplied as standard allows the UPS to be replaced without shutting down the equipment it powers. Around 15 minutes of runtime at half load (4 000 W), extendable with four battery cabinets.
•Around 15 minutes of runtime at half load (4 000 W)
•Runtime extendable with one to four external battery cabinets
A free-standing tower on castors, with an LCD screen showing the load, the battery status and the voltages. Around 16 minutes of runtime at half load, extendable with up to four battery cabinets.
•Around 16 minutes of runtime at half load
•Runtime extendable with one to four external battery cabinets
Four U in a rack and a battery recharged in 3 hours: it is ready to go again quickly after a cut. Around 11 minutes of runtime at half load (3000 W) and 7 minutes at 70%.
Built-in network card: monitoring and control happen remotely, from the company network. 1980 W genuinely available and ten output sockets, two of them reinforced 16 A, in a chassis meant for the rack.
Twenty minutes of runtime at half load (2 400 W), extended to several hours with up to four external battery cabinets. The standard maintenance bypass allows the unit to be swapped without shutting down the equipment.
•Around 20 minutes of runtime at half load (2 400 W)
•Runtime extendable with one to four external battery cabinets
16 kW genuinely available and around 14 minutes of runtime at half load, extendable with up to four battery cabinets. Terminal block input and output, for hard-wired infrastructure.
•16 kW usable output
•Around 14 minutes of runtime at half load
•Runtime extendable with one to four external battery cabinets
Ten battery-backed outlets, four of them heavy-duty 16 A, for 4 500 W usable and around 11 minutes of runtime at half load (2 250 W). The Web/SNMP management card is included.
•4 500 W usable output (power factor of 0.9)
•Around 11 minutes of runtime at 50% load (2 250 W), 7 minutes at 70% (3 150 W)
•6 C13 outlets, the format used by computer and server power cords, all battery-backed
•3 C19 outlets: reinforced 16 A outlets for power-hungry equipment
•Terminal block input: fixed wiring, to be installed by an electrician
In stock
39 099 DHincl. VAT39 099,00 DHincl. VAT
Delivery everywhereDelivered all over Morocco
Runtime 5 minutes at 70% load (7000 W)
•3-wire terminal block connection: fixed wiring, to be installed by an electrician
In stock
30 599 DHincl. VAT30 599,00 DHincl. VAT
Delivery everywhereDelivered all over Morocco
•Internal bypass and maintenance bypass as standard
In stock
29 999 DHincl. VAT29 999,00 DHincl. VAT
Delivery everywhereDelivered all over Morocco
•Internal bypass and maintenance bypass as standard
In stock
41 999 DHincl. VAT41 999,00 DHincl. VAT
Delivery everywhereDelivered all over Morocco
•
Runtime 7 minutes at 70% load (4200 W)
•Height 4U in a rack
In stock
27 299 DHincl. VAT27 299,00 DHincl. VAT
Delivery everywhereDelivered all over Morocco
•
Built-in network card to monitor and control the UPS remotely
•1980 W genuinely available
•8 C13 outlets, the format of computer and server power cords
In stock
27 099 DHincl. VAT27 099,00 DHincl. VAT
Delivery everywhereDelivered all over Morocco
•Internal bypass and maintenance bypass as standard
Ten battery-backed outlets, four of them heavy-duty 16 A, for 4 500 W usable and around 11 minutes of runtime at half load (2 250 W). The Web/SNMP management card is included.
•4 500 W usable output (power factor of 0.9)
•Around 11 minutes of runtime at 50% load (2 250 W), 7 minutes at 70% (3 150 W)
•6 C13 outlets, the format used by computer and server power cords, all battery-backed
Three reinforced 16 A outlets for power-hungry hardware, eight server outlets, and batteries that are changed without cutting the power. Under 40 dB at one metre, in a rack as in a tower.
•8 C13 outlets: the format of computer and server power cords
Power factor of 1: all 8 000 W stated are available. Ten battery-backed outlets, four of them heavy-duty 16 A, and the Web/SNMP network management card is included.
•8 000 W usable output (power factor of 1)
•6 C13 outlets, the format used by computer and server power cords, all battery-backed
Twenty minutes of runtime at half load (2 400 W), extended to several hours with up to four external battery cabinets. The standard maintenance bypass allows the unit to be swapped without shutting down the equipment.
•Around 20 minutes of runtime at half load (2 400 W)
Up to four external battery modules extend the 10.5 minutes of runtime at half load. The 2U rack mounting kit, the output cords and the USB cable are included.
•Runtime: 10.5 min at half load, 3.5 min at full load
•Runtime extendable by up to 4 external battery modules
Every outlet is battery-backed, with around 11 minutes of runtime at half load (990 W). Automatic and manual internal bypass, LCD screen and a detachable 2.44 m cord supplied.
16 minutes of runtime at half load (800 W), and under 37 dB: it can sit next to a workstation without being heard. Its batteries are replaced without cutting the power.
•16 minutes of runtime at half load (800 W)
•7 minutes of runtime at full load
•6 C13 outlets, the format used by computer and server cords
2400 W genuinely available and 13.5 minutes of battery life at half load (1200 W): time enough to save and shut down cleanly. Under 37 dB, it can stay beside the workstation it protects.
Quiet at under 37 dB, it holds 11.5 minutes at half load (400 W): enough to save and shut down a NAS or a small server without losing anything. Its batteries are replaced without cutting the power.
•11.5 minutes of runtime at half load (400 W)
•5 minutes of runtime at full load
•4 C13 outlets, the format used by computer and server cords
Four U in a rack and a battery recharged in 3 hours: it is ready to go again quickly after a cut. Around 11 minutes of runtime at half load (3000 W) and 7 minutes at 70%.